Three Methods and Result Comparison for Drawing Inclined Floor Slabs in Revit
During the Revit modeling process, you may sometimes need to create an inclined floor slab. How can you accurately draw a sloped slab in your model? Below are three effective methods to achieve this.
Method 1: Using the Slope Arrow
Step 1: After defining the floor boundary, click the Slope Arrow button. Draw arrows indicating the direction of the slope. Be sure to place the arrowheads precisely on the sketch lines, as the slope calculation depends on the arrow’s start and end positions.
Step 2: In the Properties panel on the left, set the arrow tail offset value (the height offset at the arrow tail). Finally, click the Complete button to finish drawing the inclined slab. Refer to Figure 2 for an example.
Method 2: Defining the Slope
Step 1: After creating the floor boundary, select the sketch boundary segment that you want to modify.
Step 2: Enable the Define fixed height option by checking its box. Then, check the Define Slope box as well. In the dimension annotation field labeled Slope, enter the desired slope value. Click Complete to finish drawing the inclined floor slab. See Figure 3 for details.
Method 3: Modifying Sub-Elements
Step 1: After creating the floor slab, select it and open the Properties panel. Click the Edit Type button to open the Type Properties dialog. Click Structure on the right side, then click Edit to open the Edit Assembly dialog. In the structure editor, uncheck the Variable option. Click OK twice to exit.
Step 2: Select the floor slab again and switch to the Modify | Floor tab. Click the Modify Sub Elements button. Then, click the offset value (typically “0”) at the edge point you want to adjust, and enter the required offset value for the inclined side. This will complete the inclined slab drawing. Refer to Figures 4 and 5 for examples.
Comparison of Results from the Three Methods
The image below compares the results of the three methods, shown from left to right as Slope Arrow, Define Slope, and Modify Sub Elements. All methods draw a sloped slab with a thickness of 250mm.
From the comparison, it’s clear that both the Slope Arrow and Define Slope methods maintain the slab thickness consistently. However, the width at the junction with the horizontal slab is increased, as shown in the image below.
On the other hand, the Modify Sub Elements method keeps the connection thickness between the inclined and horizontal slabs consistent, but the slab thickness reduces along the slope.
>> Read more similar articles
Must log in before commenting!
Sign Up